CCNA training in Kochi | CCNP training in kochi | Emigo Networks | CCIE Training in Kochi, Cochin, Kerala | CCIE, CCNP, CCNA, MCSE, MCITP

Red Hat® Certified Engineer (RHCE)

System configuration and management

• Use network teaming or bonding to configure aggregated network links between two Red Hat Enterprise Linux systems.
• Configure IPv6 addresses and perform basic IPv6 troubleshooting.
• Route IP traffic and create static routes.
• Use firewalld and associated mechanisms such as rich rules, zones and custom rules, to implement packet filtering and configure network address translation (NAT).
• Configure a system to authenticate using Kerberos.
• Configure a system as either an iSCSI target or initiator that persistently mounts an iSCSI target.
• Produce and deliver reports on system utilization (processor, memory, disk, and network).
• Use shell scripting to automate system maintenance tasks.


Network services

Network services are an important subset of the exam objectives. RHCE candidates should be capable of meeting the following objectives for each of the network services listed below:

• Install the packages needed to provide the service.
• Configure SELinux to support the service.
• Use SELinux port labeling to allow services to use non-standard ports.
• Configure the service to start when the system is booted.
• Configure the service for basic operation.
• Configure host-based and user-based security for the service.


• Configure a virtual host.
• Configure access restrictions on directories.
• Deploy a basic CGI application.
• Configure group-managed content.
• Configure TLS security.


• Configure a caching-only name server.
• Troubleshoot DNS client issues.


• Provide network shares to specific clients.
• Provide network shares suitable for group collaboration.
• Use Kerberos to control access to NFS network shares.


• Provide network shares to specific clients.
• Provide network shares suitable for group collaboration.


• Configure a system to forward all email to a central mail server.


• Configure key-based authentication.
• Configure additional options described in documentation.


• Synchronize time using other NTP peers.


Database services

• Install and configure MariaDB.
• Backup and restore a database.
• Create a simple database schema.
• Perform simple SQL queries against a database.
• Configuring static routes, packet filtering, and network address translation.
• Setting kernel runtime parameters.
• Configuring an Internet Small Computer System Interface (iSCSI) initiator.
• Producing and delivering reports on system utilization.
• Using shell scripting to automate system maintenance tasks.
• Configuring system logging, including remote logging.
• Configuring a system to provide networking services, including HTTP/HTTPS, File Transfer Protocol (FTP), network file system (NFS), server message block (SMB), Simple Mail Transfer Protocol (SMTP), secure shell (SSH) and Network Time Protocol (NTP).

RHCE 7 objective now has an additional topic for Database services, where you will have to Install and configure MariaDB, backup and restore a database, create a simple database schema and perform simple SQL queries against a database.

The performance-based Red Hat Certified Engineer exam (EX300) tests to determine if your knowledge, skill, and ability meet those required of a senior system administrator responsible for Red Hat Enterprise Linux (RHEL) systems. Red Hat Certified System Administrator (RHCSA) certification is required to earn RHCE certification.

RHCE training in kochi | CCIE training in kochi Emigo
All Rights Riserved @ 2017 Emigo Networks
Powerd byHost On